Making a 'close to' regulation AKC obedience jump set

Disclaimer:
These directions are offered FREE of charge. There are no guarantees given or implied as to the success of these projects nor can I be held responsible for problems that you or your dog experience during or after construction. Use your own commonsense, always double check the math and if you have any questions, please send me an Email me   and I will try to help you figure out the problem.
Be safe and enjoy,
Rita Geiger

Tools needed for project:

• Power drill
• 1/8" and 1/4" metal drill bits
• Hand or circular saw (fine tooth)
• Tape measure
• 36" ruler, preferably metal
• Flat screw driver or ¼" nut driver
• Pen/pencil for marking
• Heavy duty scissors
• Medium grit sandpaper (for taking off burrs on pvc)
• Square
• Miter box
• Goggles for eye protection

A few words before you get started (Read me)

The materials listed for each jump (high, bar, broad) are calculated to reduce waste. Each jump has a mention of pkg of #8 x 1/2" sheet metal screws and 4 oz of pvc glue. You won't need as much as mentioned totally but I had to include it with each jump separately.

You will see a note that some pieces are meant for another jump. I have given separate instructions for each jump to make it less confusing when cutting and combining the pieces. Total material cost at this time is about $50. Detailed drawings and pictures are included for each jump. Do not hesitate to Email me   me if you have any questions. RG

Thank you to my husband Lloyd for his shop, equipment, and patience and a good friend Carol Harmon who years ago sat down with me one Saturday afternoon and put it all on paper.

Print and save